Furman M-8L Power Conditioner

Condition: Used



Affordable Protection from Furman!

Protect your gear without breaking the bank! The Furman M-8L Merit Series power conditioner offers top-notch protection for your gear, at a price point that doesn’t break the bank – perfect for any rack system. The M-8L Provides access to eight switched outlets on the rear panel – including wall-wart spacings – to power and protect all your equipment, up to a 15-amp load. To provide discreet illumination of your equipment on stages, in studios, and in other dark places, the M-8L features two slide-out, swiveling light fixtures.

You’ve got a rack for your effects, preamps, tuner…but you’re going to plug that straight into the wall? One big spike and your rig is up in smoke!  The Furman M-8L’s standard level surge/spike protection defends your gear from the spikes and surges that are so common at gigs and practice spots. You’ll get a quieter tone without pops, crackles, and the local radio station coming out of your amp.

Can’t track down where that noise is coming from? Your mix sounding flat? With the M-8L’s standard level RFI/EMI filtration, you’ll lower the noise floor caused by the dirty AC power coming into your console or DAW. Furman’s standard level surge and spike protection keeps your sensitive digital equipment from acting funny or burning up due to everyday spikes and surges. With a 15A capacity and nine total outlets, it’s enough to power your whole home studio.

Bars, clubs and other event venues have some of the worst power out there – from air compressors turning on and off to light shows pulling current loads up and down. And, the AC power can be a strain on the circuits in your rig. The Furman M-8L’s standard level protection and filtration keeps the bad stuff out.

When you’re out there gigging, you never know what kind of power you’re going to get. The wear and tear on mobile rigs eventually takes it toll – that’s why it’s smart to plug into the M-8L’s standard level protection and RFI/EMI filtration. It keeps your equipment safe and sounding clean. Whether you’re setting up a show at the local club or powering up the church band for their next service, make sure you give them power they can trust.

Furman M-8L Features:

  • Maximum Output Current: 15 amps
  • Line Cord: 6 ft., captive, 14 AWG, with 3-conductor Edison plug
  • Operating Voltage: 120VAC 60Hz
  • Lamps: Two 120V incandescent bulbs, 4 watts each
  • Spike Protection Mode: Line to neutral
  • Energy Dissipation: 170 joules
  • Peak Impulse Current: 12,000 amps
  • Maximum Continuous Operating Voltage: 130 VAC RMS
  • Let Through Voltage (@ 125 amps, 8/20uS waveform) 400 volts
  • Noise Attenuation: Transverse mode: Greater than 23dB, 200Khz to 10 MHz
  • Dimensions: 1.75″ H x 19″ W x 7.5″ D
  • Weight: 5.5 lbs.


M-8L Image Gallery